Tap the soundbar’s display, go to Speaker Setup, Pairing and select Surround Setup. You will then be guided through the pairing process.

To successfully pair the speakers, all speakers must be in pairing mode (the LED lights will flash white). You can (re)activate pairing mode by pressing and holding the reset button on the back of the surround speakers for 20 seconds until you hear a soft beep and the LED lights begin flashing. Then start the pairing process via the soundbar’s display.


The same applies to the subwoofer. If no speakers are found, check whether each speaker is receiving power, reset your soundbar and speakers and try the setup process again.


Watch the instructional video on how to do this for the Citation Bar here: